As a precision mechanical equipment, if it is not placed in a reasonable environment, it is very easy to damage the fuselage, so we must strictly control the site and use requirements of the machining center, which can refer to the following points.

The general processing center is installed in the machining workshop, not only the ambient temperature changes, the use of poor conditions, and a variety of mechanical and electrical equipment, resulting in large fluctuations in the power grid. Therefore, the position of the installation of the Full Automatic Hydraulic Machine requires strict control of the power supply voltage. Power supply voltage fluctuations must be within the allowable range and remain relatively stable. Otherwise, it will affect the normal work of the Full Automatic Hydraulic Machine CNC system.

The ambient temperature of the Full Automatic Hydraulic Machine is less than 30 degrees, and the relative temperature is less than 80%. In general, the CNC electric control box is equipped with an exhaust fan or chiller to keep the electronic components, especially the central processor, at a constant operating temperature or a small temperature difference. Excessive temperature and humidity will lead to reduced life of the control system components and lead to increased failure. The increase in temperature and humidity, the increase in dust will produce a bond in the integrated circuit board, and lead to short circuit.

When using a Full Automatic Hydraulic Machine, the user is not allowed to change the parameters set by the manufacturer in the control system at will. The setting of these parameters of the Full Automatic Hydraulic Machine is directly related to the dynamic characteristics of each component of the Full Automatic Hydraulic Machine. Only the value of the gap compensation parameter can be adjusted according to the actual situation.

The Full Automatic Hydraulic Machine should be away from the vibration source, avoid direct sunlight and thermal radiation, and avoid the influence of moisture and airflow. If there is a vibration source near the Full Automatic Hydraulic Machine, an anti-vibration tank should be installed around the Full Automatic Hydraulic Machine. Otherwise, it will directly affect the processing accuracy and stability of the Full Automatic Hydraulic Machine, which will lead to poor contact of electronic components, cause failures and affect the reliability of the Full Automatic Hydraulic Machine.

Full Automatic Hydraulic Machine https://www.zjshuangzheng.com/Full-Automatic-Hydraulic-Machine-Tapping-Type-SZ-CZ-50S.html